Get an account | | Accounts are free. Join #retro on irc.fxnet.org, identify with NickServ and type !req. | | [ how ] |
|
| IRC | #retro on irc.fxnet.org 6697 ssl · 6667 plain modern + vintage clients welcome | | [ vintage how-to ] |
|
| Some stats | | releases | 1,766 | | last 24h | +750 | | online | 404.1 GB | | library | 1.2 TB | | members | 0 | | updated | 2026-10-04 23:40 |
|
|
| | Power Macintosh G3 Minitower Processor Module Wire Screw Replacement |
| Device | Power Macintosh G3 Minitower |
| Difficulty | Easy |
| Time | No estimate |
| Steps | 4 |
This guide is by LeoI07 on iFixit and is licensed under Creative Commons Attribution-NonCommercial-ShareAlike 3.0. ByteRot mirrors it for non-commercial preservation: formatting changed and photos resized for old browsers; full-size photos and the text are on the FTP in /DOCS/REPAIR. Original guide >>
Tools: Phillips #1 Screwdriver |
|
| Step 1 :: Side Access Panel | Press the green release button on top of the side access panel. Pull off the side access panel to get inside the computer. NOTE: When putting the side access panel back on, make sure that the bottom of the panel lines up with the rail on the bottom, and that the chassis is locked with the green latches.
|
|
| Step 2 :: Opening the Chassis | Lay the computer on its side, ensuring that where the side access panel was is facing up.
|
|
| Step 3 | Unlock the top chassis by moving the two green locking latches upward and outward. Using the handle, gently swing the top chassis up and out until it rests firmly on the work surface.
|
|
| Step 4 :: Processor Module Wire Screw | Using a Phillips screwdriver, unscrew the screw on the logic board holding the processor module wire in place. CAUTION: When screwing down the wire, be careful not to damage the capacitor next to the screw hole.
|
|
| Conclusion | | To reassemble your device, follow these instructions in reverse order. |
|
|